WebMay 28, 2024 · mlxlink is a link debugging tool introduced in MFT 4.7. The tool is used to check and debug link status and related issues. The tool can be used on different links … WebSep 24, 2024 · Here are the ways to disable FEC on the card: Connect it to a switch that does not support FEC because our cards set to auto-negotiate by default, meaning if the other side also supports FEC, FEC is enabled. if not, FEC is disabled. Disable FEC from the switch side, if it’s a Mellanox switch then run: “ interface ib 1/1 fec-override no-fec ...
Twitterの犬アイコンに“裏コマンド”で普通の芝犬が…粋な遊び心 …
WebMar 8, 2024 · How to use mlxup tool. The mlxup tool allows an easy firmware upgrade procedure for Mellanox's adapter cards. This video and many other professional videos … WebAug 19, 2024 · mlxlink -d /dev/mst/mt4119_pciconf0 --link_mode_force --speeds 25G. Then you must toggle the link so the above changes will take place: mlxlink -d mt4119_pciconf0 -a TG. Regards, Chen. m.serdienis August 19, 2024, 1:04pm 3. Sad, but that did not helped :- Have not tried other card, because I do not have spare cards, other 2 card are in ... may i have your attention please 翻译
mlxlink - Mellanox
WebDownload and install the mlxlink tool available at the following URL: Mellanox Firmware Tools (MFT) Start the MST service and identify : # mst start # mst status; Note: The name of device shown in the outputshould be something like /dev/mst/mt4119_pciconf0 (ConnectX 5) and will refer to it as DEVICE. WebThe mlxlink tool is used to check and debug link status and issues related to them. The tool can be used on different links and cables (passive, active, transceiver and backplane). … may i have your feedback on below email